Time Zone

Setting the time zone

Date and Time on the digital controller are set and managed by the server, there is not a clock to set on the controller. To set the time for your device, select the appropriate time zone for your installation.

From the controller summary page select the Setting Cog from the Information Panel



From the pop up window select the Time Zone from the drop down menu and then click SAVE

 

    • Related Articles

    • Minimum Relay Run Time

      When a relay is turned on or off the relay has a default STATE time of 5 seconds. This 5 second minimum STATE time is built into the operation system and may not be overridden by a user.  Motorized valves often require a minimum amount of time to ...

    • Setting the Deadband

      When configuring an output and a probe value is being used to drive the relay, the Feed Type may include a Deadband option. A Deadband is the offset created to prevent short cycling or toggling of a relay.  This offset allows the value to climb above ...

    • PERIOD FEED

      The PERIOD FEED is used to drive an output using a PERIOD (cycle time) and percentage of the defined PERIOD called Feed on Percentage. The PERIOD FEED is time based and does not rely on a sensor input.  To configure the PERIOD FEED complete the ...

    • One Time Passcode, no passwords

      Zeus does not use passwords. ZEUS Software uses Multi Factor Authentication (MFA) to access the platform. Each time you log in you will be sent a One Time Passcode (OTP). This offers a higher level of security and over are the days of trying to keep ...

    • Manual run time for a relay

      A user may override a relay's programming and drive the relay (output) for a define period of MINUTES.  This is sometimes referred to as a "slug feed" or "hand mode".  To drive a relay for a set period of time: 1. From the Summary Page click on the ...